The LED Light Link is a device that facilitates the conversion and synchronisation of a circuit made up of new LED indicators, regardless of the electronics on board.
This device is the ideal solution when facing the problem of converting from a traditional 21W direction circuit to a new one that uses LED technology with the impossibility of replacing the flashing light on board or simply not knowing if this electronic part complies with the requirements for regulation 13207-1.
More emblematically, when it is necessary to add to the vehicle, for example, a trailer with LED indicators, but unfortunately you do not known exactly whether the on-board flashing light (or the CPU) complies with the standards that regulate diagnostics in LED technology: the LED Light Link thus makes the trailer – or simply the vehicle’s direction circuit that uses LED turn signals – effectively universal so that it can be coupled to any tractor regardless of the electronics on board.
It is simply necessary to install one LED Light Link per side for each pair of LED turn signals.
If the LED turn signal is working (with power greater than 1W) a temporary resistor will light up. In addition, in the event that the LED turn signal breaks down (with power less than 1W), the resistor turns off, thus activating the fault signal to the flashing light on-board or to any CPU.
The device integrates the system for the detection of trailers connected to tractors equipped with ECU according to the recent ISO 13207-1 standard.
12V and 24V versions are available.
Led Failure Threshold: ˂ 40mA @ rated voltage
No Failure Pulse Simulation: 2 x 21w resistor
Num. Terminals: 3
Operating Voltage: 18 ÷ 32V
Output Regulated Voltage (W3-W4): 24V ± 0,2V DC
Direction Indicator Range Power Rating: Min 1W @18V - Max 10W @ 32V
Cold Check Failure Detection: Available
Rated Load: 2 X 21W
Rated Voltage: 24V DC
Electrical Lifestime in Hazard mode: 36h
Reverse Polarity Protection: - 28V DC
Short Circuit Protection: Present
Degree Protection: IP 68 DIN40050
IP Protection: Available
Connection: Loose ADR Cables
Operating Temperature: -40°C ÷ 50°C
Diagnostics: Present, a failure warning
Storage Temperature: -40°C ÷ 110°C
Test Temperature: + 23°C
Rubber Component: EPDM
Resin Compound: High Temp Heat Dissipation Resin UL94-V0
Housing: EN AB 46100 ALUMINIUM HEATSINK/SANDBLASTED
Cables: oflex truck 170 flryy /ADR Cable 3x1,00mm²
Preferential Origin: Made in Italy
In Conformity with: ISO 13207 "Led Lamp Characteristics for bulb compatible failure detection PART 1: Led lamps used as direction indicators"
Homologation Number: 10R-05 0031
Company IMDS: 75948
Salt Spray Test (ISO 16750-3): 96h @ 5% NaCl
Packing Options: 1pcs/10pcs/35pcs
Single Net Weight: 515g